As a result, the plasma expands outward faster and to the larger radius exerting more pressure in the surrounding including onto the redeposited plasma vapor condensates on the target surface. This creates the external pressure approximately similar to or higher than the internal pressure of the redeposited material, hence hindering the formation of stems, stage 4 of Figure 8. The this website excessive temperature of the plasma species and the target can also remelt the deposited material as well as previously grown stems and tips. The SEM image of the target

irradiated with 13-MHz repetition rate for the dwell time of 0.75 ms depicted in Figure 9c is the perfect example of the stage 4 illustrated in Figure 8. For 8-MHz Ipatasertib manufacturer repetition rate at 0.75-ms dwell time, most of the redeposited material Quizartinib in vivo must be experiencing approximately equal internal and external pressure resulting in the formation of just circular micronanoparticles rather than the formation of stems. There is an evident of the formation of very few tips from bulk droplets in Figure 9b. If we follow the

above four stages, there should not be any tip growth for 13-MHz repetition rate for the dwell time of 0.75 ms. However from Figure 9c, it can be seen that a significant number of nanotips grew on the target. This happened because the 13-MHz repetition rate provides a much larger number of pulses and the machining is performed way beyond stage 4 of the growth mechanism. When the plasma reaches stage 4, it will exert excessive pressure and temperature on previously

deposited material resulting in remelting and formation of micronanoparticles. But at the same time, since plasma is continuously being heated by incoming pulses, plasma will rapidly expand outward. There will be a point in time where the plasma has expanded far enough from the redeposition RVX-208 site relieving excessive pressure and temperature. From this point onward, the transmission of the subsequent laser pulses will improve, and the new material will be ablated from the target forming new plasma over the target surface. This whole phenomenon must be occurring in the last part of the 0.75-ms dwell time during which the growth mechanism starts back at stage 1 and forms nanotips on previously deposited material, as seen in Figure 9c. Figure 9 Effect of excessive machining of irradiation spot corresponding to various repetition rates. Nanostructures generated at the dwell time of 0.75 ms for the repetition rates of (a) 4, (b) 8, and (c) 13 MHz for 214 fs. Effect of laser polarization All the experiments discussed above were performed by circular polarization of femtosecond laser pulses. We also wanted to investigate whether the linear polarization changes the growth mechanism of nanostructures on the laser-irradiated target glass. The effect of laser polarization on the ablation of various materials has been studied by many researchers. Hee et al.